CHARGER-INVERTER (Studer XTH6000-48) 48/230V 100A 5kVA

The Studer Xtender XTH6000 charger-inverter 48 V, 100 A, 6000 VA is a combination of an 48 V, 5000 W inverter and a battery charger. The integrated battery charger provides up to 100 A charge current which allows quick charging even for bigger batteries as long as there is an AC input.

The 48 V sine inverter converts the DC battery voltage into 230V AC. Due to a pure sine wave this inverter is also suitable for sensitive electronic devices.
An integrated relay switches over from AC input to inverter output. And it switches back when power is restored at the input. The whole process is controlled fully automatic.

Features:

• true sine wave inverter
• 6 steps charging: bulk, absorption, floating, equalization, reduced floating, periodic absorption
• transfer switch with short switch over time: <15 milliseconds
• parallel operation of multiple Xtender XTH6000 devices possible
• 3-phase system configurable with 3 Xtender XTH6000 devicesr
• remote control available

INVERTER:

• input voltage range battery (DC): 38-60 V
• output voltage: 230 VAC, 50 Hz
• continuous output power at 25 °C: 5000 VA
• peak power (5 seconds): 15 kVA
• maximum efficiency: ~96 %
• zero load power: 22 W

CHARGER:

• AC input voltage range: 150-265 VAC, 45 – 65 Hz
• max. charge current: 100 A
• battery temperature sensor: yes

GENERAL

• input: 1 AC
• outputs: 1 AC
• 2 x multifunction contact
• rcc, xcom communication interfaces
• remote control, monitoring, data logging available
• operating temperature: -20 to +55°C
• Transfer switch (input/output current max.): 50/80 A
• connectors:
• battery: cable lug M8
• input/output: screw terminals 10 mm²
• protection functions:
• overload protection
• short-Circuit protection
• overheat protection
• IP20, only for dry location

Read manual before use and installation. Further support documention, including back-up sizing, can be found on your logistical knowledge base.